![]() ![]() Next insert one of the clips into the holes on the end of the plug, on the side where the prongs are more difficult to press down. The prongs are the same distance apart as the clips on the snes plug. If they don't move, use a xacto knife to break the weld on the seam.įirst, straighten the paper clip, cut it in half and bend it into shapes shown in the picture below. You can check this by holding the outer casing and moving the connector piece in and out. You will need one of the thicker paper clips, I don't know what size they are, but they are not the small flimsy ones.ĮDIT: Before you start, make sure the two pieces are not friction welded together. Ok, I figured out a method that worked easily for me.
0 Comments
Leave a Reply. |